ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3042 > < Initial Inspection and Diagnostic Overview|Page 3040
Page 70
background image

-------------------------------------------------
V38 VERIFY VEHICLE EQUIPMENT - HVAC MODULE

-

Inspect the vehicle for an HVAC module.

-

Is the vehicle equipped with an HVAC module?

Yes

GO to V39.

No

GO to V40.

-------------------------------------------------
V39 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE HVAC MODULE
DISCONNECTED

-

Disconnect: HVAC Module C228a (EATC) or C2357a (EMTC).

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit
VDB07 (VT/OG), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT all modules. CONNECT the negative battery cable. GO to V62.

No

GO to V42.

-------------------------------------------------
V40 VERIFY VEHICLE EQUIPMENT - APIM

-

Inspect the vehicle for an Accessory Protocol Interface Module (APIM).

-

Is the vehicle equipped with an APIM?

Yes

GO to V41.

No

GO to V42.

-------------------------------------------------
V41 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE APIM DISCONNECTED

-

Disconnect: APIM C3342.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit
VDB07 (VT/OG), harness side and ground.

Initial Inspection and Diagnostic Overview|Page 3042 > < Initial Inspection and Diagnostic Overview|Page 3040