ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3043 > < Initial Inspection and Diagnostic Overview|Page 3041
Page 71
background image

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT all modules. CONNECT the negative battery cable. GO to V63.

No

GO to V42.

-------------------------------------------------
V42 VERIFY VEHICLE EQUIPMENT - AUDIO RCU

-

Inspect the vehicle for an audio Rear Control Unit (RCU).

-

Is the vehicle equipped with an audio RCU?

Yes

GO to V43.

No

GO to V44.

-------------------------------------------------
V43 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE AUDIO RCU DISCONNECTED

-

Disconnect: Audio RCU C3077.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit
VDB07 (VT/OG), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT all modules. CONNECT the negative battery cable. GO to V64.

No

GO to V44.

-------------------------------------------------
V44 VERIFY VEHICLE EQUIPMENT - RETM

-

Inspect the vehicle for a Rear Entertainment Module (RETM).

-

Is the vehicle equipped with an RETM?

Yes

GO to V45.

No

GO to V46.

-------------------------------------------------
V45 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE RETM DISCONNECTED

-

Disconnect: RETM C949.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit

Initial Inspection and Diagnostic Overview|Page 3043 > < Initial Inspection and Diagnostic Overview|Page 3041