Expedition 2WD V8-5.4L (2009)
observed when working with these components or component damage can occur. Always install blanking plugs to any open orifices or tubes.
1. If servicing a liquid fuel tube, release the fuel system pressure. For additional information, refer to Fuel System Pressure Release See: Fuel
Filter/Fuel Pressure Release/Service and Repair.
2. Disconnect the battery ground cable.
3. NOTICE: Do not use any tools. The use of tools may cause a deformity in the clip components which may cause fuel leaks.
Depress the legs of the retainer clip and position the clip to the outward position.
4. Disconnect the quick connect coupling from the fuel tube.
Connect - Type V
1. Inspect and clean both quick connect coupling ends.
2. NOTE: Apply clean engine oil to the end of the tube and the quick connect coupling O-ring seals.
Install the quick connect coupling onto the fuel tube until fully seated.
3. NOTICE: Do not use any tools. The use of tools may cause a deformity in the clip components which may cause fuel leaks.
NOTE: Make sure the retainer clip is fully seated and locked onto the fuel tube by pulling on the quick connect coupling.
Press the retainer clip into the quick connect coupling body until flush and the legs are locked in place.
4. Connect the battery ground cable.
Disconnect - Type VI
WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component.
