Expedition 2WD V8-5.4L (2009)
Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING: Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any
fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in
serious personal injury.
WARNING: Before working on or disconnecting any of the fuel tubes or fuel system components, relieve the fuel system pressure to prevent
accidental spraying of fuel. Fuel in the fuel system remains under high pressure, even when the engine is not running. Failure to follow this
instruction may result in serious personal injury.
WARNING: When handling fuel, always observe fuel handling precautions and be prepared in the event of fuel spillage. Spilled fuel may be
ignited by hot vehicle components or other ignition sources. Failure to follow these instructions may result in serious personal injury.
NOTICE: When reusing liquid or vapor tube connectors, make sure to use compressed air to remove any foreign material from the connector
retaining clip area before separating from the tube or damage to the tube or connector retaining clip can occur. Apply clean engine oil to the
end of the tube before inserting the tube into the connector.
NOTICE: Fuel injection equipment is manufactured to very precise tolerances and fine clearances. It is essential that absolute cleanliness is
observed when working with these components or component damage can occur. Always install blanking plugs to any open orifices or tubes.
1. If servicing a liquid fuel tube, release the fuel system pressure. For additional information, refer to Fuel System Pressure Release See: Fuel
Filter/Fuel Pressure Release/Service and Repair.
2. Disconnect the battery ground cable.
3. NOTICE: Do not use any tools. The use of tools may cause a deformity in the clip components which may cause fuel leaks.
Unclip the locking tab.
4. Depress the tabs and press the clip downward.
5. Separate the quick connect coupling.
Connect - Type VI
1. Inspect and clean both quick connect coupling ends.
2. NOTE: Make sure the fuel tube clicks into place when installing the tube. To make sure that the fuel tube is fully seated, pull on the tube.
NOTE: Apply clean engine oil to the end of the tube and the quick connect coupling O-ring seals.
