Expedition 2WD V8-5.4L (2009)
rear of the transmission.
2. Install the front fuel supply tube into the vehicle and clip it into the bracket at the bellhousing and install it into the bracket at the rear of the
transmission.
3. Install the fuel vapor tube into the vehicle and clip it into the bracket at the bellhousing and install it into the bracket at the rear of the transmission.
4. NOTE: Front pushpin retainer shown, other similar.
Connect the 3 transmission wiring harness pushpin retainers to the bracket at the transmission bellhousing, the transmission housing and the
bracket at the rear of the transmission.
5. Install the HO2S electrical connector wiring pushpin to the fuel supply tube, fuel vapor tube, and fresh air tube bracket at the rear of the
transmission housing and connect the LH HO2S sensor electrical connector.
6. Install the selector lever bracket and 2 bolts.
-
Tighten to 48 Nm (35 lb-ft).
7. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the cable end is
snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the cable to click into place. Pull back on the selector lever
cable to make sure that it is locked in the bracket. Also, make sure that the selector lever cable end is correctly installed onto the ball stud. Pull
back on the selector lever cable to make sure that the cable end is correctly installed.
With the manual lever in NEUTRAL, connect the selector lever cable onto the manual lever ball stud and move the locking tab downward into the
locked position.
-
Listen for the audible click.
-
Pull back on the selector lever cable to make sure it is correctly installed.
8. If equipped, install the selector lever heat shield.
