ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Engine, A/T Controls - Delayed/Harsh Downshifts|Page 220 > < Engine, A/T Controls - Delayed/Harsh Downshifts
Page 2
background image

b. Using PDS:

(1) Choose all Tests and Calibrations

(2) Scroll down the menu and choose reset 1CM KAM

NOTE

FOR PDS, RESET TCM KAM IS NOT THE SAME AS CLEAR TRANSMISSION ADAPTIVE TABLES, WHICH IS UNDER THE
POWERTRAIN - TRANSMISSION MENU TREE.

NOTE

UNHOOKING THE BATTERY WILL NOT CLEAR THE TCM KAM. IT IS CRITICAL THAT TCM KAM BE CLEARED PRIOR TO
RELEARNING THE ADAPTIVE TABLES FOR THE TRANSMISSION.

NOTE

DO NOT CLEAR THE PCM KAM.

4. Verify that the transmission fluid temperature (TFT) PID is above 175 °F (80 °C). If it is not at 175 °F (80 °C), drive unit approximately 3 miles (5

Km) to reach temperature.

NOTE

TFT MUST BE AT 175 °F (80 °C) OR ABOVE BEFORE PROCEEDING TO STEP 5.

NOTE

PERFORM ADAPTIVE SHIFT STRATEGY LEARN ON LEVEL SURFACE ROAD.

5. Drive unit to perform adaptive shift strategy learn.

a. Accelerate from a stopped position with light throttle to 15 MPH (24 Km/h) and remove foot from accelerator pedal.

b. Brake very gently to a complete stop, allow at least six (6) seconds.

c. Repeat steps (a-b) five (5) times in the dealership parking lot or similar setting.

d. Accelerate from rest with light throttle ensuring that the 1-2, 2-3 and 3-4 shifts occur at engine speeds between 1700-2000 RPM.

e. Continue to accelerate until you achieve 50 MPH (80 Km/h) or the 5-6 upshift.

f. Brake gently to a complete stop and hold foot on brake for ten seconds.

g. Repeat steps (d-f) three (3) times.

NOTE

SEVERAL DAYS OF DRIVING ARE REQUIRED FOR THE TRANSMISSION TO FULLY ADAPT.

WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage 
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.

OPERATION

DESCRIPTION

TIME

101204A

2009-2010 Expedition,

1.0 Hr.

Navigator, F-150:
Reprogram The PCM And
TCM, Includes Time To
Clear KAM And Perform
Road Tests (Do Not Use
With Any Other Labor
Operations)

DEALER CODING

CONDITION

BASIC PART NO.

CODE

RECAL

42

Engine, A/T Controls - Delayed/Harsh Downshifts|Page 220 > < Engine, A/T Controls - Delayed/Harsh Downshifts