Expedition 2WD V8-5.4L (2009)
2. Install the safety canopy module B-pillar bracket hook in the sheet metal.
3. Install the safety canopy module B-pillar bracket bolt.
-
Tighten to 9 Nm (80 lb-in).
4. Install the safety canopy module roof bracket bolt.
-
Tighten to 9 Nm (80 lb-in).
5. Install the 2 safety canopy module rear bolts.
-
Tighten to 9 Nm (80 lb-in).
6. Install the C-pillar safety canopy module bolt.
-
Tighten to 9 Nm (80 lb-in).
Expedition EL/Navigator L vehicles
7. Install the safety canopy module rear tether anchor bracket and bolt to the D-pillar.
-
Tighten to 9 Nm (80 lb-in).
8. Attach the 3 safety canopy module rear tether routing clip pin-type retainers to the sheet metal.
Expedition/Navigator vehicles
9. Install the safety canopy module rear tether anchor bracket and bolt to the D-pillar.
-
Tighten to 9 Nm (80 lb-in).
10. Attach the safety canopy module rear tether routing clip pin-type retainer to the sheet metal.
All vehicles
11. Install the 2 safety canopy module front bolts.
-
Tighten to 9 Nm (80 lb-in).
