Expedition 2WD V8-5.4L (2009)
11. NOTICE: Do not touch the electrical connector pins or the exposed solenoid tabs on the mechatronic unit. Electrostatic discharge may
occur and may cause damage to the mechatronic unit.
Pull the transmission vehicle harness electrical connector out of the transmission.
12. NOTICE: During removal of the mechatronic assembly, the thermal bypass valve will fall out of the transmission case. Damage to the
valve will occur if the valve falls out.
Remove the 11 bolts from the mechatronic assembly and remove the mechatronic assembly and the bypass valve.
13. Remove the park rod actuating plate.
14. Remove the manual control lever.
1. Remove the roll pin.
2. Slide the manual control lever shaft out of the case.
3. Hold the spacer to keep it from falling out of the case.
4. Remove the manual valve inner lever and the park rod as an assembly.
