Expedition 2WD V8-5.4L (2009)
16. Remove any excess grease from the mating surface. Seat the boot in the joint boot groove.
17. Set the halfshaft assembled length to specification. For additional information, refer to Specifications.
18. NOTE: Do not damage the boot.
Insert a dull screwdriver blade under the boot to release the pressure.
19. NOTE: Tighten the through-bolt until the tool is in the closed position.
Using the Constant Velocity Joint Boot Clamp Installer, install the 2 boot clamps.
20. NOTICE: Verify the spline engagement by checking for spline lash before installing the halfshaft nut or damage to the component may
occur.
Install the halfshaft in the vehicle. For additional information, refer to Halfshaft See: Removal and Replacement in the Removal and Installation
portion.
