Expedition 2WD V8-5.4L (2009)
Wheel Bearing: Service and Repair
Front Suspension
Wheel Bearing and Wheel Hub
Removal and Installation
NOTICE: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result
in major service expense. New parts must be installed with the same part numbers or equivalent parts, if replacement is necessary. Do not use a
replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct
retention of these parts.
1. Disconnect the wheel speed sensor electrical connector.
2. Remove the wheel and tire.
3. Remove the wheel speed sensor harness bracket bolt and detach the harness from the retainers.
-
To install, tighten to 12 Nm (106 lb-in).
