Expedition 2WD V8-5.4L (2009)
4. NOTICE: Do not allow the caliper and anchor plate assembly to hang from the brake hose or damage to the hose may result.
Remove the 2 bolts and position the caliper and anchor plate aside.
-
Support the caliper using mechanic's wire.
-
To install, tighten to 200 Nm (148 lb-ft).
5. Remove the brake disc.
6. Remove the 4 bolts and the wheel bearing and wheel hub.
-
Discard the bolts.
-
To install, tighten to 175 Nm (129 lb-ft).
7. If installing a new wheel bearing and wheel hub, remove the wheel speed sensor bolt and the wheel speed sensor.
-
To install, tighten to 18 Nm (159 lb-in).
8. NOTICE: If the original wheel bearing and wheel hub is being installed, a new O-ring seal must be installed or damage to the wheel
bearing may occur.
To install, reverse the removal procedure.
