Expedition 2WD V8-5.4L (2009)
Windshield Washer Reservoir: Service and Repair
Washer Reservoir
Removal and Installation
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
Failure to follow these instructions may result in serious personal injury.
NOTICE: When servicing the windshield washer pump, be careful not to damage the windshield washer pump seal.
NOTICE: Do not operate the windshield pump before filling the windshield washer reservoir. Failure to do so may result in premature pump
failure.
NOTE: The washer reservoir is integrated with the battery tray and cannot be serviced separately.
1. Remove the vehicle battery.
2. Drain the cooling system.
3. Disconnect the upper radiator hose at the radiator inlet, and position aside.
4. Remove the 3 battery tray bolts.
-
To install, tighten to 17 Nm (150 lb-in).
5. Carefully position the washer reservoir assembly to gain access to the electrical connectors and washer hoses.
6. Disconnect the windshield washer solvent level electrical connector, washer pump electrical connectors and washer hoses.
7. NOTE: If necessary, drain the windshield washer reservoir after removal.
