Expedition 4WD V8-5.4L VIN 5 (2006)
5. WARNING: Anytime the safety canopy module has deployed, the headliner, and all A, B, and C pillar upper trim panels and attaching
hardware must be replaced along with any other damaged components and hardware. Failure to do so may result in personal injury in
the event of a safety canopy module deployment.
Install the driver side C-pillar trim panel.
1
Position the driver side C-pillar trim panel and push in, engaging the retainers.
2
Install the bolt and bolt cover.
-
Tighten to 11 Nm (8 lb-ft).
3
Install the weather-stripping along the driver side C-pillar trim panel.
6. NOTE:
-
Inspect the shoulder safety belt guide cover for damage. If the shoulder safety belt guide cover is damaged or if it does not remain closed,
install a new shoulder safety belt guide cover.
-
Make sure the safety belt is not twisted prior to installation.
Install the second row driver side safety belt guide.
1
Position the second row driver side safety belt guide.
2
Install the nut.
-
Tighten to 40 Nm (30 lb-ft).
3
Close the safety belt guide cover.
-
Verify the safety belt retractor operates without excessive effort or binding.
7. Remove the restraint system diagnostic tool from the vehicle harness side of the passenger side safety canopy electrical connector.
