Expedition 4WD V8-5.4L VIN 5 (2006)
2. CAUTION: Care must be taken to avoid scratching the pinch weld.
Trim the remaining urethane adhesive on the pinch weld to within specification.
-
The old urethane surface should be smooth and free of cuts and contamination.
3. If reinstalling the original windshield, remove excess urethane adhesive from the windshield glass.
4. If installing a new windshield glass, clean the inside of the glass surface with an alcohol-free cleaner to make sure the ceramic-coated area is clean.
5. CAUTION: Be sure to use the same brand and cure-rate products for the adhesive and primer. Do not mix different brands of urethane
and primer. Refer to the Material Chart in this procedure.
NOTE: Sika uses the same black primer for the glass and pinch weld area.
If installing a new windshield glass, apply urethane glass primer according to manufacturer's instructions. Allow at least 6 minutes to dry.
6. Install the upper windshield weatherstrip.
7. Cut the urethane applicator tip to specification.
