Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
-
Remove the rear disc brake caliper.
1. Remove the brake caliper bolts.
2. Lift the rear disc brake caliper off the rear disc brake caliper anchor plate.
CAUTION: Do not remove the guide pins or guide pin boots unless a problem is suspected. The guide pins are meant to be sealed for life and are
not repairable. At the time of publication there are no approved materials or procedures for re-lubing the caliper slide pins. Other greases may
swell the guide pin boots resulting in contamination and accelerated corrosion or wear of the caliper slide pin mechanism.
-
Inspect the rear disc brake caliper for leaks.
^ If leaks are found, disassembly is required.
Measuring Rear Disc Brake Rotor
-
Measure the rear disc brake rotor thickness.
^ Replace the rear disc brake rotor if not within specification (10.4 mm or 0.409 inch).
INSTALLATION:
Installing Rear Disc Brake Caliper
-
Install the rear disc brake caliper.
1. Install the rear disc brake caliper.
2. Install the brake caliper bolts.
CAUTION: To prevent interference with rear disc brake caliper operation, install only the correct caliper bolt.