Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
12. Connect the TCC, SS4, SS2, and EPC solenoid electrical connectors.
13. Install the wire loom guide and protector.
-
Align the retaining pins to the holes in the solenoid clamps and gently press in the wire loom guide and protector.
CAUTION: Excessive pressure may break the retaining pins.
14. Install the transmission fluid pan filter and a new transmission fluid pan gasket.
15. Lower the vehicle.
NOTE: If equipped with air suspension, reactivate the system by turning on the air suspension switch.
16. Connect battery ground cable.
17. Fill transmission to proper fluid level and check for proper transmission operation.
-
Use MERCON V Automatic Transmission Fluid meeting Ford specification XT-5-QM.