Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
Valve Body: Service and Repair
Assembly
1. Thoroughly clean all parts in solvent and blow dry with moisture free compressed air.
CAUTION: Do not lose parts when servicing.
2. After cleaning the main control valve body, perform the following:
-
Inspect all valve and plug bores for scoring or burrs.
-
Check all fluid passages for obstructions.
-
Inspect all valves and plugs for burrs.
-
Inspect all mating surfaces for burrs or distortion.
-
Inspect all springs for distortion.
-
Check all valves and plugs for free movement in their respective bores.
>
Valves and plugs, when dry, must fall from their own weight into their respective bores.
-
Roll the manual valve on a flat surface to check for a bent condition.
3. Clean and inspect the EPC solenoid screens.
4. Remove and replace all shift solenoid O-rings.
5. Clean and inspect the torque converter clutch (TCC) solenoid.
6. Clean an] inspect the electronic pressure control (EPC) limit circuit screen. Install the EPC limit circuit screen.
CAUTION: Make sure that the screen is properly located.