Explorer 2WD V6-245 4.0L VIN X SFI (1999)
ASSEMBLY
1. Install the wire harness.
2. If equipped, and if necessary, install the seat cushion heating element.
3. Position the seat cushion trim cover.
NOTE: When installing a new seat cushion trim cover, it may be necessary to cut a hole for the front seat back pad adjusting cable, backrest
heating element electrical lead, and the side air bag wiring harness. Use the old seat cushion trim cover as a guide for the location of the hole.
4. Install the seat cushion swing rods.
1. Position the swing rods.