Explorer 2WD V6-245 4.0L VIN X SFI (1999)
5. CAUTION: Do not apply pressure on the power steering pump rotor shaft Pressure will damage internal thrust areas of the power
steering pump.
Using the special tool, remove the power steering pump pulley.
^
Inspect the pulley for paint marks in the web area near the hub. If there are two paint marks, discard the pulley. If there is no paint or one paint
mark, use a paint pencil to mark the web area of the pulley near the hub.
6. Remove the bolts and the power steering pump.
Installation
1. Position the power steering pump and install the bolts.
2. CAUTION: Install a new power steering pump pulley after it has been removed and installed two times.
