Explorer 2WD V6-4.0L VIN K Flex Fuel (2002)
8. Carry out the following:
1
NOTE: The retainer clip on the shift cable will only slide into the bracket in one direction.
Connect the shift cable to the bracket.
2
Connect the shift cable to the transmission selector lever arm and support.
3
Position the wire shield and install the four screws.
9. Seat the rubber grommet in the bulkhead opening.
10. Position the lower steering column shroud and install the three screws.
11. Position the lower steering column opening finish panel and install the screws.
12. Rotate the gearshift lever clockwise until it bottoms out (first gear), then rotate it counterclockwise three detents (D position).
13. Hang a 1.4 kg (3 lb) weight on the gearshift lever.
14. Raise and support the vehicle.