Explorer 2WD V8-4.6L (2008)
Passenger seat receiving a new seat track
3. Remove the inboard and outboard OCS rails.
Passenger seat not receiving a new seat track
4. NOTE: Note the position and the routing of the OCS sensor wiring, connector and wiring retainers for installation.
Detach the 2 OCS wiring retainers at each OCS rail. Then using a suitable tool, release the tab and disconnect the RH and LH OCS rail electrical
connectors.
All seats
5. Remove the cushion side shield in the following sequence.
1
If equipped, remove the clip and manual recline handle.
2
If equipped, pull and remove the manual lumbar control knob.
3
Remove the scrivet.
4
Release the cushion side shield front clip.
5
From under the cushion side shield, release the 3 hook retainers.
6
Pull out on the cushion side shield at the back and release the pin-type retainer.
7
Separate the cushion trim cover elastic strap from the cushion side shield.
-
If equipped with a manual seat track, remove the cushion side shield.
8
If equipped with power seats, remove the seat control switch knob and separate the seat control switch from the cushion side shield.
-
Remove the cushion side shield.
Power seat
6. Separate the seat control switch wire harness pin-type retainer from the cushion frame.
Driver seat
7. Disconnect the SRS seat position sensor.