Explorer 2WD V8-4.6L (2008)
-
Tighten to 8 Nm (71 lb-in).
8. Install the 2 safety canopy module rear bracket bolts.
-
Tighten to 8 Nm (71 lb-in).
9. Install the safety canopy module C-pillar tether bracket and the 2 bolts.
-
Tighten to 12 Nm (9 lb-ft).
10. Attach the 3 safety canopy module front tether pin-type retainers to the A-pillar.
11. NOTE: Make sure the safety canopy module front tether bracket locator tab is correctly installed in the A-pillar sheet metal.
Install the safety canopy module front tether bracket and bolt.
-
Tighten to 8 Nm (71 lb-in).
Vehicles with entertainment system
12. NOTE: Make sure to route the entertainment system wiring as noted during removal.
Attach the 2 entertainment system wiring retainers.
Vehicles with moon roof
13. NOTE: Make sure to route the moon roof drain hose as noted during removal.
Connect the rear moon roof drain tube and attach the 2 rear moon roof drain hose clips.
All vehicles
14. NOTE: Make sure to route the safety canopy module wiring harness as noted during removal.
Connect the safety canopy module electrical connector and attach the connector and wiring pin-type retainers to the C-pillar.
Vehicles with auxiliary climate control
15. Install the auxiliary climate control headliner duct and 2 retainers to the C-pillar.