Explorer 2WD V8-4.6L VIN 8 (2006)
A2-A3
Normal Operation
The PCM communicates with the diagnostic tool through the high speed controller area network (CAN), circuits VDB04 (WH/BU) and VDB05
(WH). The PCM and instrument cluster share network termination responsibilities with the use of a split termination resistor in each module. Check
the high speed CAN circuits between the PCM C175b and the data link connector (DLC) C251. The total resistance values must not be more than 5
ohms. If the resistance is more than 5 ohms there is an open in one of the high speed CAN circuits, damage to the DLC C251, damage to the PCM
C175b, or a problem in an in-line connector.
Possible Causes
-
high speed CAN data plus circuit VDB04 (WH/BU) open
-
high speed CAN data minus circuit VDB05 (WH) open
-
PCM C175b
-
PCM
Test B: The Transmission Control Module (TCM) Does Not Respond To The Diagnostic Tool
PINPOINT TEST B: THE TRANSMISSION CONTROL MODULE (TCM) DOES NOT RESPOND TO THE DIAGNOSTIC TOOL
