Explorer 2WD V8-4.6L VIN 8 (2006)
K2-K3
Normal Operation
The EATC module communicates with the diagnostic tool through the medium speed controller area network (CAN), circuits VDB06 (GY/OG) and
VDB07 (VT/OG). Check the medium speed CAN circuits between the EATC module C228a and the data link connector (DLC) C251. The total
resistance values must not be more than 5 ohms. If the resistance is more than 5 ohms there is an open in one of the high speed CAN circuits, damage
to the DLC C251, damage to the EATC module C228a, or a problem in an in-line connector.
Possible Causes
-
medium speed CAN data plus circuit VDB06 (GY/OG) open
-
medium speed CAN data minus circuit VDB07 (VT/OG) open
-
EATC module C228a
-
EATC module
Test L: The Retractable Running Board Module Does Not Respond To The Diagnostic Tool
PINPOINT TEST L: THE RETRACTABLE RUNNING BOARD MODULE DOES NOT RESPOND TO THE DIAGNOSTIC TOOL