Explorer 2WD V8-4.6L VIN 8 (2006)
14. Remove and discard the manual control lever seal.
Installation
1. Position a new manual control lever seal in place.
2. Using the special tool, install a new manual control lever shaft seal.
3. Install the manual lever in the case.
1
Slide the manual lever in the case.
2
Position the spacer in place while sliding the manual lever into the spacer.
3
Position the manual valve inner lever while sliding the manual lever and lining up the roll pin hole.
4
Install the roll pin.
4. Position the park, rod in place. Push down on the park pawl and position the park rod in place.