Explorer 2WD V8-4.6L VIN 8 (2006)
5. While holding the park rod down, install the park rod actuating plate.
^
Tighten to 10 Nm (89 inch lbs.).
6. CAUTION: Do not touch the electrical connector pins or the exposed solenoid tabs on the TCM. Electrostatic discharge may occur and may
cause damage to the mechatronic unit.
Position the mechatronic assembly in place and loosely install the 11 bolts.
7. Tighten the mechatronic bolts in the sequence shown.
^
Tighten to 8 Nm (71 inch lbs.).
8. CAUTION: Do not touch the electrical connector pins. Electrostatic discharge may occur and will cause damage to the mechatronic unit.
With the release tab down and unlocked, push the outer shell of the bulkhead electrical connector into the transmission. Make sure that the