Explorer 4WD V6-4.0L VIN E (1999)
2. NOTE: Clean the halfshaft boot mounting surfaces of excess grease before positioning the halfshaft boot into place.
Position the outboard halfshaft boot and outboard boot clamps.
1
Position the outboard halfshaft boot.
2
Position the boot clamps on the outboard halfshaft boot.
3. NOTE: Tighten the through-bolt until the installer is in the closed position.
Use the CV Boot Clamp Installer to install the outboard CV joint boot clamps.
4. Position the boot clamp on the halfshaft.
5. Position the inboard halfshaft boot.
6. Install a new stop ring, if necessary.