Explorer 4WD V8-302 5.0L VIN P SFI (2000)
8. Note: Offset the Gauge Block to obtain an accurate reading.
Rotate the Gauge Block several half-lures to make sure of correct seating of the pinion bearings and position the Gauge Block.
9. Install the special tool.
1. Position the special tool.
2. Install the bearing caps.
3. Install the four bolts.
10. Note: Use only flat, clean drive pinion bearing adjustment shims.
Note: Selection of too thick a pinion shim results in a deep tooth contact at final assembly of integral rear axle assemblies. Do not attempt to force
the pinion shim between the Gauge Block and the Gauge Tube. A slight drag indicates correct shim selection.
Use a drive pinion bearing adjustment shim as a gauge for shim selection.
-
Check the pinion bearing adjustment shim thickness between the Gauge Block and the Gauge Tube.
-
After determining the correct shim thickness, remove the special tools.
