Explorer AWD V8-4.6L (2010)
-
Are the resistances greater than 1,000 ohms?
Yes
CONNECT the negative battery cable. GO to T4.
No
CONNECT the negative battery cable. GO to Pinpoint Test U. See: Pinpoint Test U: No High Speed Controller Area Network (HS-CAN)
Communication, All Modules Are Not Responding
-------------------------------------------------
T4 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO VOLTAGE
-
Ignition ON.
-
Measure the voltage between the DLC C251-6, circuit VDB04 (WH/BU), harness side and ground; and between the DLC C251-14, circuit
VDB05 (WH), harness side and ground.
-
Are the voltages greater than 6 volts?
Yes
REPAIR the circuit in question. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
GO to T5.
-------------------------------------------------
T5 CHECK FOR RESTORED COMMUNICATION WITH THE PCM DISABLED
NOTE: A scan tool session must be established prior to disabling the PCM in this test step. If the PCM has failed communication during multiple
attempts to identify the vehicle, first identify the vehicle manually by entering a PCM part number, calibration number or tear tag when prompted by the
IDS.
NOTE: When a vehicle is manually identified by a PCM part number, calibration number or tear tag, the IDS will not automatically run a network test.
The network test must be manually selected and run.
-
Disconnect: BJB Fuse 24 (10A) and 39 (15A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuses. GO to Pinpoint Test A. See: Pinpoint Test A: The PCM Does Not Respond To The Scan Tool
No
INSTALL the removed fuses. GO to T6.
-------------------------------------------------
T6 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE ABS MODULE AND 4X4 CONTROL MODULE (IF
EQUIPPED) DISABLED