Explorer AWD V8-4.6L (2010)
NOTE: When re-running the network test, the network test application must first be closed or the screen display reverts back to the prior run network
test results.
-
Disconnect: SJB fuse 18 (10A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. If the vehicle is equipped with a 4X4 control module, GO to T7. If the vehicle is not equipped with a 4X4 control module,
GO to Pinpoint Test C. See: Pinpoint Test C: The ABS Module Does Not Respond To The Scan Tool
No
INSTALL the removed fuse. GO to T8.
-------------------------------------------------
T7 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE ABS MODULE DISCONNECTED
NOTE: When re-running the network test, the network test application must first be closed or the screen display reverts back to the prior run network
test results.
-
Disconnect: ABS Module C155.
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
CONNECT the ABS module. GO to Pinpoint Test C. See: Pinpoint Test C: The ABS Module Does Not Respond To The Scan Tool
No
CONNECT the ABS module. GO to Pinpoint Test E. See: Pinpoint Test E: The 4X4 Control Module Does Not Respond To The Scan Tool
-------------------------------------------------
T8 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE RCM AND OCSM DISABLED
NOTE: When re-running the network test, the network test application must first be closed or the screen display reverts back to the prior run network
test results.
-
Disconnect: SJB Fuse 17 (10A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. GO to T9.
No
INSTALL the removed fuse. GO to T10.
-------------------------------------------------
T9 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE RCM DISCONNECTED
NOTE: When re-running the network test, the network test application must first be closed or the screen display reverts back to the prior run network
test results.
-
Disconnect: RCM C310b.
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?