Explorer AWD V8-4.6L (2010)
Yes
CONNECT the RCM. GO to Pinpoint Test D. See: Pinpoint Test D: The Restraints Control Module (RCM) Does Not Respond To The Scan Tool
No
CONNECT the RCM. GO to Pinpoint Test F. See: Pinpoint Test F: The Occupant Classification System Module (OCSM) Does Not Respond To The
Scan Tool
-------------------------------------------------
T10 VERIFY VEHICLE EQUIPMENT - TCM
-
A TCM is present in 6R60 transmission-equipped vehicles only. Inspect the vehicle for a 6R60 transmission.
-
Is the vehicle equipped with a 6R60 transmission?
Yes
GO to T11.
No
GO to T12.
-------------------------------------------------
T11 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE TCM DISABLED
NOTE: When re-running the network test, the network test application must first be closed or the screen display reverts back to the prior run network
test results.
-
Disconnect: BJB Fuse 27 (20A) and SJB Fuse 9 (2A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuses. GO to Pinpoint Test B. See: Pinpoint Test B: The Transmission Control Module (TCM) Does Not Respond To The Scan
Tool
No
INSTALL the removed fuses. GO to T12.
-------------------------------------------------
T12 VERIFY VEHICLE EQUIPMENT - APIM
-
Inspect the vehicle for an APIM.
-
Is the vehicle equipped with an APIM?
Yes
GO to T13.
No
GO to T14.
-------------------------------------------------
T13 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE APIM DISABLED
NOTE: When re-running the network test, the network test application must first be closed or the screen display reverts back to the prior run network
test results.
-
Disconnect: BJB Fuse 41 (15A).
-
Enter the following diagnostic mode on the scan tool: Network Test.