Explorer Sport Trac 4WD V6-245 4.0L SOHC VIN K SFI (2001)
2. Seat new wheel studs in the axle flange.
-
Place four flatwashers over the outside end of the wheel stud.
-
Thread a standard wheel nut with the flat side against the washers.
-
Tighten the wheel nut until the wheel stud head seats against the back side of the flange.
3. Remove the wheel nut and flatwashers.
4. Install the brake disc, rear disc support bracket and the rear disc brake caliper, if so equipped.
5. Install the wheel and tire assembly.
6. Lower the vehicle.