Workshop Manuals Factory service & repair Ford
01 Service Information02 Suspension03 Driveline04 Brake System05 Steering System06 Engine07 Automatic Transmission08 Manual Transmission, Clutch and Transfer Case09 Exhaust System10 Fuel System11 Climate Control System12 Instrumentation and Warning Systems13 Battery and Charging System14 Audio Systems15 Lighting16 Electrical Distribution17 Electronic Feature Group18 Body19 Frame and Mounting20 Wiring diagrams21 Wiring – connector views22 Wiring – component locations
Ford F-150 Factory Service Manual (2007)20 · Wiring diagrams
20 · Electrical

Introduction – sheet 5

Make
Ford
Model
F 150 2WD F-150 Factory Service Manual
Year
2007
Section
003 Introduction › Introduction – sheet 5
Wiring diagramsIntroduction – sheet 5

Introduction – sheet 5

Wiring diagram 3-5 · 2007 F-150/Mark LT

View full sizeFit to page

WARNINGSAlways wear safety glasses for eye protection.To avoid injury, always remove rings, watches, loose hanging jewelryDo not smoke when working on a vehicle.and avoid wearing loose clothing.present in and around the battery cell. An explosion could occur.Do not allow flame or sparks near the battery. Gases are alwaysmuffler.the radiator, exhaust manifold, tail pipe, catalytic converter andTo prevent serious burns, avoid contact with hot metal parts such asengine is running.Keep away from moving parts, especially the fan and belts, when thecarbon monoxide.Operate the engine only in a well-ventilated area to avoid danger ofNEUTRAL.transmission should be in PARK. A manual transmission should be inSet the parking brake when working on any vehicle. An automaticUse safety stands whenever a procedure requires being under avehicle.Be sure that the IGNITION SWITCH is always in the OFF position, unlessotherwise required by the procedure.!

Parts & tools for this job For 2007 Ford F 150 2WD

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.