F 150 2WD Pickup V8-4.6L (2002)
2. Seat new wheel stud in axle flange or hub flange.
-
Place four flat washers over the outside end of the wheel stud.
-
Thread a standard wheel nut with the flat side against the washers.
-
Tighten the wheel nut until the wheel stud head seats against the back side of the flange.
3. Remove the wheel nut and flat washers.
Vehicles with disc brakes
4. Install the brake disc, rear disc support bracket and the rear disc brake caliper, if so equipped.
Vehicles with drum braless
5. Install the rear brake drum.
All vehicles
6. Install the wheel and tire assembly.
7. Lower the vehicle.