F 150 2WD Pickup V8-5.4L SOHC VIN 5 (2004)
Remove the hydraulic lash adjusters.
Item 2-5: LH Camshaft Bearing Cap Bolts, Bearing Caps, and Camshaft Installation Note
1. Lubricate the camshaft journals with clean engine oil.
2. Install the camshaft and the camshaft bearing caps in their original locations.
^
Lubricate the camshaft bearing caps with clean engine oil.
^
Position the front camshaft bearing cap.
^
Position the remaining camshaft bearing caps.
^
Install the bolts loosely.
3. Tighten the bolts in the sequence shown to 10 Nm (89 inch lbs.).
4. CAUTION: Do not remove the timing chain wedge tool at any time during assembly. If the special tool is removed or out of placement, the
engine front cover must be removed and the engine must be retimed.
CAUTION: Damage to the camshaft phaser sprocket assembly will occur if mishandled or used as a leveraging device.
CAUTION: The timing chain must be installed in its original position onto the camshaft phaser sprocket using the scribed marks, or damage to
valves and pistons will result.
