F 150 2WD Pickup V8-5.4L SOHC VIN 5 (2004)
Part 2
6. Remove the parts in the order indicated in the illustrations and tables.
Item 1: Fuel Filler Cap Removal Note
1. Remove the fuel filler cap.
2. Remove the screws.
Items 5, 7, 8 and 11: Quick Release Fitting Removal Note
1. CAUTION:
-
Fuel injection equipment is manufactured to very precise tolerances and fine clearances. It is therefore essential that absolute
cleanliness is observed when working with these components. Always install blanking plugs to any open orifices or tubes.
-
When reusing liquid or vapor tube connectors, make sure to use compressed air to remove any foreign material from the connector
retaining clip area before separating from the tube.
NOTE: If the fuel tube retainer clip is broken or damaged, install a new clip using a suitable fuel line disconnect tool to separate the retaining clip
legs. Once the retainer legs have been separated, lift the clip out of the connector housing, lifting from the stamped side of the connector body.
Disconnect the quick release fitting.
-
Push the connector toward the tube to release pressure.
