F 150 2WD Pickup V8-5.4L SOHC VIN 5 (2004)
-
The ECU must be correctly positioned and securely fastened in place. Failure to do so can set a diagnostic trouble code (DTC) in the restraints
control module (RCM).
Item 9: Seat Cushion Foam Pad Installation Note
1. CAUTION:
-
Inspect the seat cushion pad and pan for any foreign objects before installing the seat cushion pad to the seat cushion pan. If any
foreign objects are found, remove them. Failure to do so may result in personal injury, in the event of an air bag deployment.
-
While positioning the seat cushion pan and occupant classification sensor assembly, be careful not to damage any of the components.
Failure to do so can result in component failure.
Align the seat cushion foam pad wire to the seat cushion pan ears and install the hog rings.
Item 10: Seat Cushion Trim Cover Installation Note
1. CAUTION:
-
It is necessary to rezero the OCS system when a front passenger seat cushion is disassembled, a new trim cover installed, or an OCS
service kit is installed. A scan tool is used to trigger the active command to carry out rezeroing of the OCS system.
-
Inspect the seat cushion pad and seat cushion trim cover for any foreign objects, before installing the seat cushion trim cover to the
seat cushion pad. If any foreign objects are found, remove them. Failure to do so may result in personal injury, in the event of an air
bag deployment.
-
While positioning the seat cushion pan and occupant classification sensor assembly, be careful not to damage any of the components.
Failure to do so can result in component failure.
Install hog rings to attach the seat cushion trim cover to the seat cushion foam pad at all locations from where they were removed.
2. At the front outboard of the seat cushion pan, attach the two clips.
