F 150 2WD Pickup V8-5.4L SOHC VIN 5 (2004)
12. Rotate the driveshaft 180 degrees, reinstall the punch tool, and remove the remaining driveshaft flange bearing cup from the driveshaft flange.
13. Remove the differential flange bearing cups from the differential flange in the same manner.
14. NOTE: Inspect the bearing cup bores and retaining ring grooves. Remove any rust or other surface irregularities.
Inspect the universal joint bearing cup bores of the flanges and driveshaft. Make sure that all raised indications of stakes are removed and the
bores are clean and smooth.
Items 4 and 5: Universal Joint Installation Note
1. Align the driveshaft components.
2. NOTE: Install the Universal Joint Kit as a complete assembly only. Do not mix components from other kits.
NOTE: Lubricate the flange and driveshaft universal joint bores with grease before installing the bearing cups.
Install the bearing cup.
^
Position the new spider in the driveshaft yoke.
^
Start the new bearing cup into the driveshaft yoke.
^
Position the flange in the special tool.
