F 150 2WD Pickup V8-5.4L SOHC VIN 5 (2004)
2. Trim the remaining urethane adhesive on the pinch weld to within specification. The surface should be smooth and free of cuts and contamination.
3. Use the wool applicator to apply adhesive metal primer to any exposed metal on the pinch weld. Allow six to ten minutes to dry.
4. NOTE:
-
If reinstalling the original windshield, remove excess urethane adhesive from the windshield glass.
-
Clean the inside of the glass surface with an alcohol-free cleaner, making sure the ceramic-coated area is clean.
-
Wipe off glass prep immediately after each application.
Apply urethane glass prep twice around the glass surface.
5. Apply urethane glass primer to the same area that was prepped in the previous step. Allow five minutes to dry.
6. Cut the urethane applicator tip to specification.
7. Apply a bead of urethane adhesive to the pinch weld.
8. Install the windshield by aligning it to the marks previously made.
9. After the windshield glass has set, check for water leaks and add urethane where needed.
Item 2: Y-Clip Installation Note
