F 150 4WD V8-4.6L VIN 8 (2010)
-
Separate the side air bag module from the backrest frame and disconnect the electrical connector.
-
Slide the side air bag module out of the deployment chute.
-
Route the deployment chute through the opening in the backrest foam pad.
9. NOTICE: Use care when separating the seat backrest cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from
the foam pad.
Release the J-clip from the backrest frame and partially invert the backrest cover to the row of hog rings.
10. Remove all the hog rings and backrest cover.
-
For climate controlled seat, before installation, make sure the backrest manifold is correctly fitted into the valleys in the foam pad.
11. To install, reverse the removal procedure.
Seat Cushion Cover - Front
Seat Cushion Cover - Front
Removal and Installation
NOTE: For parts identification and location, refer to Seat - Exploded View, Front See: Service and Repair/Front Seats/Seat - Exploded View, Front.
1. Remove the seat. For additional information, refer to Seat - Front See: Service and Repair/Front Seats/Seat - Front.
2. For SuperCab, remove the manual recline handle, if equipped.
-
Insert an appropriate tool behind the cushion side shield, release the retainer and remove the handle.
3. If equipped, remove the adjustable lumbar knob.
-
Adjust the lumbar until fully relaxed.
-
Release the retainer and remove the knob.
4. Remove the side shield insert.
-
Release the lower retainers and lift to release the upper retainers.
-
If equipped, disconnect the seat control switch electrical connector.