F 150 4WD V8-4.6L VIN 8 (2010)
-
If equipped, disconnect the memory SET switch electrical connector.
5. Remove the side shield.
-
Remove the front and rear side shield screw.
-
Pull the cushion side shield outward to release the retainers.
-
Reinstall all retainers back to the side shield.
6. Release cushion cover rear J-clip and rear flaps.
7. If equipped, disconnect the cushion heater mat electrical connector and detach the wiring harness.
8. Release all the cushion cover retainers and remove the cover and foam pad.
9. NOTICE: Use care when separating the seat cushion cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the
foam pad.
Remove all the hog rings and cushion cover.
-
For correct installation, make sure the rear strap on the cushion cover is looped around the cushion foam pad.
-
For climate controlled seat, before installation, make sure the cushion manifold is correctly fitted into the valleys of the foam pad.
10. To install, reverse the removal procedure.
Seat - Exploded View, Front, Center
Seat - Exploded View, Front, Center
Seat Backrest and Cushion