F 150 4WD V8-4.6L VIN 8 (2010)
Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the RH valve cover. For additional information, refer to Valve Cover - RH See: Cylinder Head Assembly/Valve Cover/Service and
Repair/Valve Cover - RH.
3. Remove the LH valve cover. For additional information, refer to Valve Cover - LH See: Cylinder Head Assembly/Valve Cover/Service and
Repair/Valve Cover - LH.
4. Loosen the 4 coolant pump pulley bolts.
5. Rotate the tensioner clockwise and remove the accessory drive belt.
6. Remove the 4 bolts and the coolant pump pulley.
7. Remove the drain plug and drain the engine oil. Install the drain plug when finished.
-
Tighten to 23 Nm (17 lb-ft).