ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3209 > < Initial Inspection and Diagnostic Overview|Page 3207
Page 92
background image

side.

-

Is the resistance greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to W57.

No

GO to W39.

-------------------------------------------------
W39 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE IC DISCONNECTED

 

-

Disconnect: Instrument Cluster (IC) C220.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Is the resistance greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to W58.

No

If the vehicle is equipped with a Power Running Board (PRB) module, GO to W40.

If the vehicle is not equipped with a PRB module, GO to W41.

-------------------------------------------------
W40 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE PRB MODULE
DISCONNECTED

 

-

Disconnect: PRB Module C3313b.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Is the resistance greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to W59.

Initial Inspection and Diagnostic Overview|Page 3209 > < Initial Inspection and Diagnostic Overview|Page 3207