F 150 4WD V8-4.6L VIN 8 (2010)
Yes
INSTALL a new telematics module. REFER to Accessories and Optional Equipment. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.
-------------------------------------------------
Y1-Y20
Communications Network
Pinpoint Tests
Pinpoint Test Y: No High Speed Controller Area Network (HS-CAN) Communication, All Modules Are Not Responding
Refer to Wiring Diagram Set 14, Module Communications Network for schematic and connector information. See: Diagrams/Electrical
Diagrams/Diagrams By Number
Normal Operation
The High Speed Controller Area Network (HS-CAN) uses an unshielded twisted pair cable, circuits VDB04 (WH/BU) and VDB05 (WH).
This pinpoint test is intended to diagnose the following:
-
Wiring, terminals or connectors
-
4X4 control module
-
ABS module
-
Accessory Protocol Interface Module (APIM)
-
Instrument Cluster (IC)
-
Occupant Classification System Module (OCSM)
-
PCM
-
Restraints Control Module (RCM)
-
Transmission Control Module (TCM)
-
Trailer Brake Control (TBC) module
-
Telematics module
PINPOINT TEST Y: NO HS-CAN COMMUNICATION, ALL MODULES ARE NOT RESPONDING
NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the
connector.
NOTE: Most faults are due to connector and/or wiring concerns. Carry out a thorough inspection and verification before proceeding with the pinpoint
test. See: Initial Inspection and Diagnostic Overview/Module Configuration/Inspection and Verification
NOTE: Failure to disconnect the battery when instructed will result in false resistance readings. Refer to Battery.
-------------------------------------------------
Y1 CHECK THE DLC PINS FOR DAMAGE
-
Ignition OFF.
-
Disconnect the scan tool cable from the Data Link Connector (DLC).
-
Inspect the DLC pins 6 and 14 for damage.