F 150 4WD V8-4.6L VIN 8 (2010)
WARNING: Always disconnect the battery ground cable at the battery when working on an evaporative emission (EVAP) system or
fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in
serious personal injury.
WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component.
Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
1. Disconnect the battery ground cable. For additional information, refer to Battery.
2. Disconnect the Evaporative Emission (EVAP) canister purge valve electrical connector.
3. Disconnect the EVAP canister purge valve vapor tube quick connect coupling from the valve. For additional information, refer to Fuel Delivery
and Air Induction.
Vehicles equipped with 4.6L (2V), 4.6L (3V) or 5.4L (3V) engine
4. Disconnect the EVAP canister purge valve hose-to-intake manifold quick connect coupling. For additional information, refer to Fuel Delivery and
Air Induction.
5. Remove the EVAP canister purge valve from the bracket.
Vehicles equipped with 6.2L (2V) engine
6. Remove the 2 EVAP canister purge valve bolts and remove the valve.
Installation
Vehicles equipped with 6.2L (2V) engine
1. Install the EVAP canister purge valve and 2 bolts.
-
Tighten to 10 Nm (89 lb-in).
Vehicles equipped with 4.6L (2V), 4.6L (3V) or 5.4L (3V) engine
2. Install the EVAP canister purge valve on the bracket.
3. Connect the EVAP canister purge valve hose-to-intake manifold quick connect coupling. For additional information, refer to Fuel Delivery and
Air Induction.
All vehicles
4. Connect the EVAP canister purge valve vapor tube quick connect coupling. For additional information, refer to Fuel Delivery and Air Induction.
5. Connect the EVAP canister purge valve electrical connector.
6. Connect the battery ground cable. For additional information, refer to Battery.
7. Carry out the Evaporative Emissions System Leak Test. For additional information, refer to Evaporative Emission System Leak Test See: Testing
and Inspection.
