F 150 4WD V8-4.6L VIN 8 (2010)
-
Listen for the audible click.
-
Pull back on the selector lever cable to make sure that it is installed correctly.
3. Place the selector lever in the 1st position toward the rear of the vehicle.
4. Install the rubber grommet and selector lever cable through the floor panel.
5. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place. Press the selector lever
cable into the bracket and listen for the selector lever cable to click into place. Pull back on the selector lever cable to make sure that it is locked
into the bracket.
Connect the selector lever cable onto the selector lever.
1. Connect the selector lever cable onto the selector lever cable bracket.
2. Connect the selector lever cable onto the selector lever arm.
-
Listen for the audible click.
-
Pull back on the selector lever cable to make sure that it is installed correctly.
6. Install the center console LH kick panel.
7. Install the console upper trim panel, console tray and cup holder inserts.