F 150 4WD V8-4.6L VIN 8 (2010)
2. Install the transmission crossmember and the 4 transmission crossmember nuts and bolts (2 each side).
-
Tighten to 90 Nm (66 lb-ft).
3. Install the Evaporative Emission (EVAP) canister front bracket bolt to the transmission crossmember.
-
Tighten to 20 Nm (177 lb-in).
4. Lower the transmission onto the transmission crossmember and install the 2 transmission insulator and retainer nuts.
-
Tighten to 103 Nm (75 lb-ft).
5. Install the LH isolator cap bolt.
-
Tighten to 35 Nm (26 lb-ft).
6. Install the LH exhaust heat shield bolt to the transmission crossmember.
-
Tighten to 15 Nm (133 lb-in).
7. Install the RH exhaust heat shield bolt to the transmission crossmember.
-
Tighten to 15 Nm (133 lb-in).