F 150 4WD V8-4.6L VIN 8 (2010)
6. Remove the main control valve body and discard the pump outlet screen.
Installation
1. NOTE: Make sure that the drive pin of the manual valve detent lever assembly engages the manual valve in the correct location prior to installing
the bolts.
NOTE: The alignment bolts are valve body assembly bolts.
Position and align the main control valve body and gasket using 2 long main control valve body bolts as a guide.
2. NOTE: The main control valve body bolts will be tightened in later steps.
Loosely install the remaining 9 long main control valve body bolts.
3. NOTE: Lubricate the EPC solenoid O-rings with transmission fluid.
Position the EPC solenoid bracket and loosely install the bolt.
4. NOTE: The main control valve body bolts will be tightened in later steps.
Loosely install the 12 short main control valve body bolts.