F 150 4WD V8-4.6L VIN 8 (2010)
5. Install the manual control valve detent lever spring and loosely install the bolt.
6. Tighten the main control valve body bolts in the sequence shown.
-
Tighten to 10 Nm (89 lb-in).
7. Inspect the transmission internal harness for damage.
8. Connect the transmission internal harness to the solenoids.
1. Connect the transmission internal harness connector by pressing it in place by hand and fully seating the connector in place.
2. Connect the EPC solenoid by pressing it in place by hand and fully seating the connector in place.
3. Connect the TCC by pressing it in place by hand and fully seating the connector in place.
4. Connect the shift solenoid SSA and SSB by pressing it in place by hand and fully seating the connector in place.
5. Connect the TFT solenoid by pressing it in place by hand and fully seating the connector in place.
9. NOTICE: The transmission internal wire harness needs to be properly routed to avoid the potential of damage to the harness. Pinched or
trapped wires may result in a transmission failure.