F 150 4WD V8-4.6L VIN 8 (2010)
Make sure that the internal wire harness is properly routed.
10. Install the transmission fluid pan and transmission fluid filter. For additional information, refer to Fluid Pan, Gasket and Filter See: Fluid Filter -
A/T/Service and Repair/4R70E/4R75E/Fluid Pan, Gasket and Filter.
Electronic Pressure Control (EPC) Solenoid
4R70E/4R75E
Electronic Pressure Control (EPC) Solenoid
Removal
1. Remove the manual control lever. For additional information, refer to Manual Control Lever Shaft and Seal See: Seals and Gaskets/Service and
Repair/4R70E/4R75E/Manual Control Lever Shaft and Seal.
2. Disconnect the transmission internal harness from the solenoids.
1. Disconnect Shift Solenoid A (SSA) and Shift Solenoid B (SSB).
2. Disconnect the Torque Converter Clutch (TCC).
3. Disconnect the Electronic Pressure Control (EPC) solenoid.
4. Disconnect the transmission internal harness connector.
5. Disconnect the Transmission Fluid Temperature (TFT) sensor.
3. Remove the EPC solenoid.
1. Remove the bolt and EPC solenoid bracket.
2. Remove the EPC solenoid.